EB Welding of gas turbine engines
Electron beam welding for fabrication and repair of gas turbine engines
Electron beam welding (EBW) is widely used in the fabrication and repair of gas turbines. The technique produces very low distortion, low heat input and a high integrity weld. Welding is carried out in a single pass and usually there are no filler additions; the closely butting joint faces are fused together by the beam.
A very wide range of materials can be EB welded, and dissimilar joints produced. This is often used for the manufacture of drums where high temperature materials are used in the combustion section of the engine.
Features:
- low distortion
- high quality weld
- dissimilar joints
- used for patches, blade replacement and platform welds
- Intense beam to produce a narrow, parallel-sided weld
- Long distance working - beams may need to be projected up to 3m across stators for welding from inside out
- These type of machines operate at up to 30kW power
|
EB welded gas turbine compressor section drum(Courtesy of igm Robotersysteme AG Steigerwald Strahltechnik) |
For further information, please contact:
power@twi.co.uk
Copyright © 2001, TWI Ltd
Information and advice from TWI and its partners are provided in good faith and based, where appropriate, on the best engineering knowledge available at the time and incorporated into TWI's website in accordance with TWI's ISO 9001:2000 accredited status. No warranty expressed or implied is given regarding the results or effects of applying information or advice obtained from the website, nor is any responsibility accepted for any consequential loss or damage.
